Hi All,
following to power problems, our servers do not have access to the most NX4 storage.
Checking by SSH (on Control Station), by running the command nas_checkup i get this results:
[root@control-station bin]# nas_checkup
Check Version: 5.6.45.5
Check Command: /nas/bin/nas_checkup
Check Log : /nas/log/checkup-run.160216-093544.log
-------------------------------------Checks-------------------------------------
Control Station: Checking if NBS clients are started....................... Fail
Control Station: Checking if NBS configuration exists...................... Pass
Control Station: Checking if NBS devices are accessible.................... Fail
Control Station: Checking if NBS service is started........................ Fail
Control Station: Checking if NAS partitions are mounted.................... Pass
Data Movers : Checking status........................................... Pass
--------------------------------------------------------------------------------
One or more error-level checks have failed. Follow the instructions
below to correct the problem and try again.
-------------------------------------Errors-------------------------------------
Control Station: Check if NBS clients are started
Symptom: NBS clients (nd-clnt 5 6) are not started
Action : Contact EMC Customer Service and refer to EMC Knowledgebase
emc146016. Include this log with your support request.
Control Station: Check if NBS devices are accessible
Symptom: Failed NBS (nd-clnt processes) devices access check
NOTE: Several checks depend on NBS device access to run. These checks
were not run.
Action :
1. This may occur if NBS is not configured correctly or if the NBS
service is not started. Look in the "Checks" section to see if the
following checks passed:
* Control Station: Check if NBS configuration exists
* Control Station: Check if NBS service is started
* Control Station: Check if NBS clients are started
If either of those checks did not pass, follow the instructions for
that check to correct the problem, then rerun "nas_checkup" to verify
that the NBS devices can now be accessed.
2. This may also occur if Data Movers are powered down or pulled out.
If you are on the primary Control Station, look in the "Checks"
section to see if the following check passed:
* Data Movers: Check status
If this check failed, follow its instructions to correct the
problem, then rerun "nas_checkup" to verify that the NBS devices can
now be accessed.
3. If the problem persists, escalate this issue through your support
organization. Provide this output and any errors or output that
occurred running the commands in this procedure in the escalation.
Control Station: Check if NBS service is started
Symptom: NBS (nd-clnt processes) service is not (or not fully) started
Action : Use the command "/sbin/service nbs start" to restart the NBS
service or reboot the Control Station.
Please can you help us?
I wish i could talk to the customer also paid.
Best Regards
Renato